News | Fenn Kayaks New Zealand |
The container has arrived in Singapore where it will be loaded onto another ship to Auckland. ETA in Auckland is 9 August. |
Oskar StielauP: 0212158327Website last updated 1 July 2022 |
Spares & Repairs
Rudders & Cables | Footrest system | Wave deflectors | Life Jackets | Bungs | Paddle Bags | Repairs
Rudders & Cables
Full Carbon Single Rudder (only 1 shape)
Full Carbon Double Rudder
(only 1 shape)
Item | Price incl. GST |
Availability |
Rudder (Carbon) | $100 | Call for shaft length |
Rudder Cables |
$2/m |
- |
Adjustable cable fastener |
$20 per set |
In stock |
Footrest System
Footrest system with cord
Construction | Price incl. GST |
Availability |
Grey weave | $250 | in stock |
Wave Deflectors
Construction | Price incl. GST |
Availability |
Carbon | $80 | in stock |
Life Jackets
Mocke Life Jackets -More than 60N floatation
Sizes | Price incl. GST |
Availability |
M/L, XL |
$180 | in stock |
Bungs
Price incl. GST |
Availability |
Bungs: $2 | in stock |
Bunghole sticker: $1 for 2 |
in stock |
Paddle Bags
Price incl. GST |
Availability |
TBC | arriving May 22 |
Repairs
Rudder repair
Rudder cable replacement usually takes about 15 minutes. Due to specialized crimping tools, you will need to bring the ski in to replace rudder cables. If this is not possible go to your local boating supplier who should have 2mm stainless steel cable and the necessary crimping tools. Make sure the crimping ferrules are stainless or nickel-coated, plain copper ferrules corrode very quickly.
Rudder installation
To install a new rudder:
1) Remove the black carbon cover at the rear of the ski. Use a Pozi #2 screwdriver to remove the screw.
2) Remove the nut on top of the old rudder and slide it out. Remove all washers.
3) Remove the nut and all the washers from the new rudder.
4) Slide the new rudder in from the bottom of the ski.
5) Add 8mm flat washers as required. See step 9 to work out the correct number of washers.
6) Slide on the bar with rudder cables attached. Make sure the square hole lines up with the square machined on the shaft.
7) Add the 6mm lock washer.
8) Screw on the M6 Nylock nut and tighten with a 10mm spanner or socket.
9) When tightening watch the gap between the rudder and the bottom of the boat. If the rudder pulls against the boat before the nut is fully tightened remove an 8mm washer. If the gap is more than 1mm with the nut fully tightened, add 8mm washers as required.
9) After the M6 nut is tight replace the black carbon cover. Don’t overtighten the screw, only tighten until the cover doesn’t move anymore.
Fibreglass or carbon repairs
Fenn Kayaks does not do fibreglass or carbon repairs. If you need fibreglass or carbon repairs done please go to your local boat repair shop or try one of the repairers listed below:
Steve Pennington
Boat Fix
58 Diana Drive, Wairau Valley
Tel: 021 908 156 or 09 441 2000
Ski construction materials:
Glass polyester resin
Poly vac polyester resin
Glass Vacuum vinyl ester resin
Carbon Hybrid epoxy resin
Carbon Vacuum epoxy resin